Tuesday, July 22, 2014

Finishing the grip area

 
 
                        Started out on this end by drilling hole for the pivot pin spring and detent.

 
Next up, mill out the material to form tabs for pivot pin.
 
Next up, mill the last surface for the grip panel.
 
Drill hole for grip. I didn't have tap on hand, so I will tap it later.
 
 
Left side mock up
 
 
Right side mock up.
 
Need to finish buffer tube hole (bore and tap), and the buffer retainer hole. Then I can start milling out the magazine pocket and the trigger group area.
 

No comments:

Post a Comment